6"/150mm Electronic Digital Vernier Caliper(E006)

Specifications

1.Measuring Range: 0-150mm/0-6in
2.Four-way measurements
3.certificate:CE
4.Display: LCD
5.Good Quality and low price

 

•SPECIFICATIONS

caliper length:23.6cm                        material:stainless steel

package:plastic casing or blister with paper card or according to your requirements.

 

•TECHNICAL SPECIFICATIONS

 Outside Jaws:           Measure External Length

Inside Jaws:              Measure Internal Length

Measuring Range:       0-150mm/0-6in, 0~200mm/ 0~8 in

Resolution:                  0.01mm/ 0.0005in

Accuracy:                     ± 0.02mm/ 0.001in (<100mm)

                                    ±0.03mm/0.001in(>100-200mm)                                      

Repeatability:               0.01mm / 0.0005in

Max Measuring Speed: 1.5m/sec, 60in/sec

Measuring System:       Linear Capacitance measuring system

Display:                         LCD Screen

Construction Material:  Stainless Steel

Power:                          One alkaline lithium button cell battery 1.5v,TYPE LR44.

                                      Capacity-180MAH

Working  Temperature: 5°c-40°c/41 to 104 degree F

Note:                  Accuracy affected in environments exceeding 80% relative humidity.

•APPLICATIONS

1.Operation : slider can be removed only after the locking screw (#10) is loosened.

2.Basic measuring methods : 

1) loosen the locking screw

2) Press "ON " button, select sae or metric measurement by pressing "MM/INCH" button. 

    Pressing "MM/INCH" button after measurement will display the sae / metric conversion.

3)To reset display to zero, close external measuring jaws, then press "ZERO" button.

MAINTENANCE INSTRUCTIONS

1. Keep the calliper clean and dry (liquid can damage the slider)

2. Use a clean, dry cloth to clean all surfaces -do not use solvents or solvent based cleaners.

3. To save power, turn off the unit when not in use.

Avoid contact with electricty and /or electronic devices

BATTERY REPLACEMENT

Flashing display indicates low battery. To replace battery, remove battery cover by sliding cover in 

the direction indicated and replace battery with positive side facing out.

 TROUBLE SHOOTING

Falure	Cause	Measure
Display flashes	Low battery	Replace battery
Display does not change  when slider is moved	System locked	Remove battery and replace  after 30 seconds to reset system
Accuracy less than +/-0.001mm	Dirt in the sensor	Remove slider cover and its  assembly, clean with compress  air 5kgs/cm2
No display on LCD	1. improper battery  position  2. Low battery	1. Remove battery cover and  check battery position  2. Replace battery.