10/100/1000M Fast Ethernet Media Converter (with External Power Supply) SFP Slot

Overview

The LNK-3011SFP is equipped with one 10/100/1000Base-T port and one Gigabit SFP slots to support conversion between 10/100/1000Base-T and 1000Base-X network. The dual SFP slots make the Ethernet signals connect easily and efficiently by adding single-mode or multi-mode media modules or the combination of both types. The LNK-3011SFP provides high reliability and flexibility to extend the media transmission distance up to 550m, 10km or longer, depending on the optional 1000Base-SX / LX SFP transceiver modules.

Features

• Support inter-conversion between adaptive 10Base-T/100Base-TX/1000Base-T with 1000Base-SX/LX

• Use Port 10/100/1000Base-TX (RJ45), 1000Base-SX/LX (SFP slot)

• Support DIP Switch Function

• Support full-duplex and half-duplex and its auto-sensed

• Support auto-sense of MDI/MDI-X, facilitating system commissioning and installation

• Support the transmission of extra-long VLAN packets

• Support Quality of Service (QoS) and ensuring the transmission of VoIP packets;

• Support Jumbo Frame (64-9216 Byte)

• Support LFP(Link fault pass through) Function

Application

Technical Indexes

Ordering Information

Remarks and Notes

Instructions on Media Converter Panel

Instructions on Front Panel

Identification for front panel of the media converter is shown below: 

a.     Identification of Media Converter

      TX - transmitting terminal; RX - receiving terminal;

b.    PWR

     Power Indicator Light – “ON” means normal operation of DC 5V power supply adaptor.

c.     1000MIndicator Light

      “ON” means the rate of the electric port is 1000 Mbps, while “OFF” means the rate is 100 Mbps.

d.    LINK/ACT (FP)

      “ON” means connectivity of the optical channel; “FLASH” means data transfer in the channel; “OFF” means non-connectivity of the optical channel.

e.     LINK/ACT (TP)

“ON” means connectivity of the electric circuit; “FLASH” means data transfer in the circuit; “OFF” means non-connectivity of the electric circuit.

f.     SD Indicator Light

“ON” means input of optical signal; “OFF” means non input.

g.    FDX/COL:

    “ON” means full duplex electric port; “OFF” means half-duplex electric port.

h.     UTP

Non-shielded twisted pair port;

Instructions on Rear Panel

Instructions on Functions of Switches: Switch-up is available while switch-down is forbidden. 
 

Instructions on Functions of Dial Switches: 

Mounting Dimensions Sketch