Q235 Steel hot-dip galvanized street light pole with spray coated

Specification:

Type

Street Lamp pole, lamp post . Lamp column

Shape

Conoid ,Multi-pyramidal,Columniform,polygonal or conical

Material

Usually   Q345B/A572,minimum yield strength>=345n/mm2
Q235B/A36,minimum yield strength>=235n/mm2
As well as Hot rolled coil from Q460 ,ASTM573 GR65, GR50 ,SS400, SS490ST52

Torlance of dimenstion

-0.02

Design Load in Kg

300~ 1000 Kg appliced to 50cm from the to pole

Surface treatment

Hot dip galvanized Following ASTM A 123, color polyester power or any other standard by client required.

Technics 

1)Basic artwork: After whole set of pole shaft hot dip galvanized, goes to static powder coating system with condition of hanging flat way within 0.3% random error. 

                                                                                                                                    2)Material: High quality steel Q235B (SS400), has enough strength to prevent deformation in transportation and installation.

Design wind power resistance: 12 Grade of 36M/S.

3)Joint welding: Applied auto welding without transverse weld. Longitudinal seam guarantee no burr no spurious joint, surface smooth.

4)Base plate use Q235B high quality steel. Flange and pole connection needs to be full welded in both side. The weld quality is reliable, secure without weld flaw.

5)Pole checking door: Auto cut door hole, cutting line is clean and smooth, with small gap less than 1mm.

6)Surface treatment: Hot dip galvanizing after GB/T 13912-92 standard. The spraying coating use American Dupont static powder. Thickness of powder coating≥110um; after GB1720,GB1732,GB1763 and ASTM F1043-95 Standard.

Length of per section

Within 15m once forming without slip joint.

Suit for

Highway 
Roadway 
Residential subdivisions 
Commercial development

Height

Height from 3m to 20m 
Flange mounted

Production Process

Raw material test → Cutting →Molding or bending →Welidng (longitudinal )→Dimension verify →Flange welding →Hole drilling →Calibration →Deburr→Galvanization or powder coating ,painting →Recalibration →Thread→Packages