Laboratory portable COD REACTOR and test tube heater XC-200 with USB connector Quality Choice

Forward

-Thanks for choosing XC-200 portable COD REACTOR and test tube heater, This manual will provide you with the necessary information for the correct use of the instrument. Please read it carefully before using the meter.

-The XC-200 thermo-reactor is constructed of durable materials with a vial capacity to perform up to 4 digestions simultaneously.

-The reactor can set the heating temperature between 20-180℃ and heating period between 0-120mins.

-The reactor contains a thermal fuse that prevents overheating, by turning off the heating element automatically with warning beep.

-A beep will be heard and the heating element will turn off at the end of the selected time period.

-The temperature is continuously displayed on the LCD even when there is no active temperature program running.

-The reactor equips transparent plastic protection shield to protect the operator.

-The reactor has USB connector which can connect with 12V Vehicle Power Adaptors for outside using.

-Please examine this product carefully. Make sure that the instrument is not damaged. If any damage occurred during shipment, please notify your Dealer.

1. Start up

Prepare the reactor as follows:

•Place the reactor on a flat table. Do not place the instrument under direct sun light.

•Connect the reactor to a power outlet with ground. Verify the correct voltage and frequency are used.

•”USB” connector is for 12V Vehicle Power Adaptors.

See the label on the instrument.

• Turn the reactor ON using the power switch located on the rear panel. Wait until unit displays the heater block temperature.

2. Heating temperature setting

Press “Mode” to choose “Temp setting”, then press UP or DOWN arrow to choose the temperature you need.

3. Heating period setting

Press “Mode” to choose “Time setting”, then press UP or DOWN arrow to choose the heating period you need.

4.Start heating

Press "Start" button to trigger heating process.The reactor will beep once the setting temperature is reached.Then,put the test tube into heater block hole,the timer will start to count down the setting period.The"balance time" shows on the screen.After the "Balance time" become "0".A beep will be heard and the heating element will turn off. It means the heating process is finished.