High Quality Metal optical emission spectrometer for Fe base

Introduction

JB750 Optical Emission Spectrometer is the best assistant for rapid quantitative analysis of metallurgical furnace and metallic quality monitoring. Its accuracy and stability meet laboratory requirements and can make measurements for dozens of matrix based on elements such as Fe,Al,Cu,Ni,Co,Ti,Mg,Zn,Sn,Pb, etc. It is widely used in steel, metallurgy, foundry and machinery for IQC, QC and OQC.
JB-750 is a design of zero fault operation, which requires little maintenance and offering high reliability and convenience.

Main Parameters
Excitation light source:
Supply voltage: 50Hz, 220V ± 1%
Input power: 1.0KVA
Charging capacitor: pre-combustion 8μF, exposure 1.5μF
Peak Current: pre-combustion 100A, exposure 20A
The main circuit peak pressure: 300VDC (with automatic adjustment of peak pressure)
Ignition circuit: pulse amplitude: +15 KV
Auxiliary gap: Using Tunnel Diode
Discharge frequency: 200 Hz ~ 600 Hz
Sample sets of gap: 4mm
Spectrometer:
Analysis band range: 160 ~ 650nm
Machine engraved concave grating: Curvature radius of 750mm
Depicts the density: 1667/mm
Incidence angle: 35 degrees
Allows a maximum of channels: 40 (expandable to 64 channels)
Spectrometer Local temperature: 35 °C ± 0.5 °C
Control System:
Measurement and Control System: The single board computer measurement and control, data exchange with the Host Computer
Reproducibility: RSD ≤ 0.2%
Photomultiplier tube high voltage power supply:
Stability: 8 hours is better than 0.5%

Test result

Apparatus installation:
1. The apparatus installation should be guided by the engineers of our company.
2. Check the goods and packing list to affirm that they are qualified and the contents match the instructions.
3. Check whether or not the lab is qualified for using the apparatus.
4. Install and start the apparatus to check if everything works well.
5. Test and adjust according to the requirements on the technical contract. Make sure that the apparatus complies with the requirements.
6. Train the users, including: operate apparatus, use software of the apparatus and daily maintenances of the apparatus.


Equipment acceptance:
Choose one or two sets of national standard samples appointed by both parties and check the equipment ,Check and analyze the precision with repeated acceptance checking program and fill the installation and acceptance checking report.


After-sales service:
1. This apparatus has a 12-month warranty since the date of install and inspection.
2. Beyond the warranty period, company will still provide after-sales service.

High Quality Metal optical emission spectrometer for Fe base