Hand Rivet Nut Gun

Specifications

This product is a special tool for installation of riveting nuts. Its force is great to rivet various riveting nuts from M8-M12.

Rivet Nut Tool is also called rivet gun.

 

How to use

1. To replace the gun head and the riveting bolt: select the suitable gun head( part 1) and riveting bolt (part 4) according to the size of riveting nut. Loosen the adjusting nut(part 3) and screw off the gun head sleeve(part 2), and place the selected gun head and riveting bolt on the gun head sleeve(part 2) and pulling rod (part 18), and then screw down. (part 2 and part 18 was inserted with the column pin). And then screw the gun head sleeve (part 2) in connection with the adjusting nut(part 3) and gun head (part 1) into the hole of gun body(part 14).
2. To adjust the length of the riveting bolt: open the two handles(part 12), adjust the gun head sleeve (part 2) to the place where the length of exposed riveting bolt is slightly longer than the riveting nut. At last screw down the adjusting nut(part 3) with the gun body(part 14)
3. Operation: open the two handles and pull out the Bakelite ball(part 29)whole, cover the relevant riveting nut on the end of the riveting bolt and clench it, boost the Bakelite ball (part 29) and riveting nut to make it possible to screw on the gun head bolt. And then insert the riveting nut into the fore-drilled hole of the work-piece and then close the two handles with force, and by now the riveting gun will expand to clinch the work-piece. Then pull out the bakelite ball and the riveting bolt quits back from the threaded hole.
4. The index ring(part 16)is used to adjust the riveting journey according to what you need in operation.
5. Note: During operation, if the screw cap is loose, please screw down it at any moment.

Specification of product:

 

 

Stuctural representation of product:

 

Photo of product:

Other tool -Crimping tool:

Hand wire rope cutter:

 

Welcome to our website: .