Reci Power Supply / Power Source for 90 - 100W Z2 / S2 CO2 Laser Tube, 110V

This power supply / power source adopts thin type design. The shape of this power supply / power source is thin which is specially designed for special laser tube. 
The power supply / power source makes laser tube output larger and more stable.

Quick Response: It can enlarge laser power and prolong laser tube‘s service life.

Easy Control: The start and stop of laser can be easily controlled by TTL level.

This power supply / power source has output open circuit protection.

This power supply / power source has TTL signal indication, water through signal indication and laser output indication.

This power supply / power source has the BUTTON to test it work properly.

Application: Sculpture and cut acrylic, fabric, double color sheet and rubber, etc

Note: The table 10A refers to the connection wire requirement, but not the actual power dissipation. 

1) The positive red - line with high voltage is connected to the laser tail

2) The negative white - line is connected to laser output window

To limit the working current, the potentiometer (Lies in the underside of the power supply / power source should be rotated in counterclockwise (Please refer to the schematic diagram in our website). Limit the maximum output current as it is regulated in the operating instruction. The working current should be limited before delivery.

Turn around the potentiometer; the linear scale will be changed: for example, when the input signal is 0 - 5V, the output current is 0 - 32mA.Or when the input signals 0 - 2V, the output signal is 0 - 32mA.

Note: When the potentiometer is turned down too much, the real output current will be brought down by the same input signal. 
 

The use standard for our power supply / power source is under 110V, 60Hz. The fluctuation of the input voltage and frequency will affect the working current provided by the power supply / power source, the impact is linear relative. The unstable of the input voltage will affect the output power of the laser tube. The fluctuation of the input voltage has no impact on the lifespan of the laser if only the current provided by the supply / power source is not over the current limitation.