MD3109 450W laser cutting or welding Electrostatic Air Filter/Smoke Absorber/electrostatic air purification system

Specifications

1. Easy design
2. esd design
3. Fit for workshop
4. Easy to Carry
5. filter Fast

MD3109 450W laser cutting or welding Electrostatic Air Filter/Smoke Absorber/electrostatic air purification system

 

 

 

 

 

 

 

 

Specification

 

Operation Instruction

 

1. Open the main roof, in turn, to the correct box in high efficiency filter, filter, the effect of initial effect sponge, open at the top, button on both sides of the buckle.

 

Should note: roof should be smoothly into housing, With sloping, cannot forced press in, otherwise it might damage the body and buckle.

 

2. Will smoke tube into the roof of the flange, the other end connection set smoke mask. Rotating pipe body, based on the use of different occasions adjust good smoking in the direction of the mouth.

Should note: smoke tube control direction, try to keep pipe shaft gentle bending, otherwise, it will affect suction force. Smoking mouth shall is working point, the distance as far as possible to remain in 150 mm less than, to ensure that the dust content can be completely suction.

 

Should note: please don't in the air flow big place to use, in order to avoid suction reduced or disappeared; Appropriate control pipe length, the longer the pipeline, suction will be more small; Conversely, suction will be bigger.

 

(3) connected to the power cord, and check the power supply plug is stable, strong.

 

4. Open on the right side of the power switch, then according to the actual need air regulation to the left of the volume knob. (below figure )

 

Should note: starting the machine, the speed control switch adjustable in wind speed minimum position.

 

 

 

 

 

Package

 

 

 

Factory Profile