Control of tobacco suckers Antak (N-decanol 79% EC)

Name: Control of tobacco suckers Antak (N-decanol 79% EC)
Brand: Cropstar
Price: USD $4.5 - 7 / Liter

FOB Price

USD $4.5 - $7 / Liter

2000 Liters(Min.Order)

Product Details

N-decanol 79% EC
1. A growth regulant with contact action for the control of tobacco sucker.
2. Lead time: 15 days.

N-decanol 79% EC

Product Description

N-decanol 79% EC is a growth regulant with contact action for the control of tobacco suckers.

ACTIVE INGREDIENT: C₁₀ (n-decanol) 79%EC

DIRECTIONS FOR USE: Use only as directed.

Compatibility:

Recommendations:

Top the tobacco plants when they are in early flowering stage.
Immediately remove any suckers over 20 mm in length by hand.
Apply DECANOL EC before the suckers have reached a length of 20 mm.
Ensure that the tobacco plants are in an upright position thus allowing the diluted emulsion to flow evenly down the stalk to come into contact with every sucker in each of the leaf axils.
Apply the solution as soon as possible, after the above steps have been taken, preferably within two days.
Do not apply if the plants are wet due to rain or dew. Wait for plants to dry before treating. Rainfall within two hours of application will reduce the effectiveness.
Do not apply in the middle of the day in very hot weather when temperatures exceed 30 °C, as leaf scorching may occur.
Do not apply to wilted plants.
Injury may occur if the solution is applied to the underside of the leaf, thus leaves must be turned over before application.
Stop application by knapsack sprayer if the wind speed exceeds 15 km per hour.

Method of application:

Add the required amount of DECANOL EC to your spray tank and then add the water to prepare the diluted emulsion.
In order to obtain the best results, it is important that the water be added to the DECANOL EC rather than the DECANOL EC to the water.
DECANOL EC may be applied either by means of a knapsack sprayer using a coarse solid cone nozzle, held about 15 to 20 cm above the top of the leaves of the plant, or by hand pouring the material onto the stems of the plant.
A coarse spray is recommended. Where a knapsack sprayer is used, a low pressure of 100 to 150 kPa is maintained and the lance is held over the plant, long enough to allow the diluted emulsion to run down to the base of the plant to ensure contact with all the suckers. Excess material will not damage the plant, but is wasted.
The alternative method of hand pouring may be done either by using a container, which applies 10 to 15 ml or by using a bottle fitted with a copper tube designed to give the correct amount, or by a dosing gun.

Application rates:

Flue-cured Tobacco: Dilute this product at the rate of 1.5 gallon of this product in 48.5 gallons of water to total 50 gallons of spray solution per acre.
Air- cured Tobacco(Burley, Cigar and Maryland): Dilute this product at the rate of 5 fluid ounces in 1gallon of water or 1.5 to 2 gallon of this product in 48 gallons of water to total 50 gallons of spray solution.
Dark Tobacco: Dilute this product at the rate of 7 to 8 fluid ounces in one gallon of water or 2.75 gallons of this product in 47.25 gallons of water to total 50 gallons of spray solution.
Note: when applied by hand, 1gallon of this diluted product will treat 130 to 190 tobacco plants. If a power sprayer is used, apply 40 to 60 gallons of diluted product per acre of tobacco.

Packaging & Shipping

Shenzhen Cropstar Chemical Industry Co., Ltd.: Contact nameDavid Meng; Phone86-755-86317161; AddressRm. 910-912, Block E, XihaiMingzhu Building, Taoyuan Road, Nanshan District Shenzhen,Guangdong

Product Categories

FUNGICIDES	HERBICIDES	New Products	PLANT GROWTH REGULATORS
RODENTICIDES

New Products