Oscilloscope SM5011

Specifications

Oscilloscope
SM5011 spectrum analyzer is used for the early test in the development of electrical products, troubleshooting of

Oscilloscope

SM5011 is equipped with a tracing signal generator, and in the combined use of spectrum analyzer/tracing signal generator, it can complete the work which cannot be done by other frequency sweep system, such as sweep generator/network analyzer, sweep generator/spectrum analyzer, and sweep generator/oscilloscope, etc.

Specifications

Input frequency response 0.15-1050MHz, 3dB Display accuracy of central frequency +/-200KHz (frequency sweep width +200KHz) Accuracy of mark frequency +/-0.1% (frequency sweep width +100KHz) Frequency display resolution 100KHz (4½ bit LED display) Frequency sweep width 0.1MHz/div-100KHz/div with 1, 2 and 5 step system And 0Hz/div (0 frequency sweep) Accuracy: +/-10% (each range) Intermediate frequency bandwidth 20KHz and 400KHz Video filter (When on) 4KHz Amplitude range -107~+13dB Reference level -27dB~+13dB (10dB for every step) +/-2dB Average noise level -97dB(20KHz intermediate frequency width) Display range of CRT screen 80 dB(10dB/div) Display range of vertical display +/-2dB (2 With attenuator) 250MHz signal Input attenuator 0-40dB (4x10dB step) error: +/-1dB/10dB Maximum input level +10dBm,+25V DC(Input attenuator set at 0dB) +20dBm (input attenuator set at 40dB) Frequency stability Over 150KHz/hour Input jack type BNC Input impedance 50Ω Power supply 220V/110V; +/-10%; 50Hz/60Hz   Tracing signal generator Input frequency response 0.15-1050MHz, 3dB Output level range -50~+1dBm (4x10dB) +/-3dB Output attenuator 0-40dB (4x10dB step) error: +/-1dB/10dB Input jack type BNC Input impedance 50Ω   Others DC output +6V (for probe) AM demodulation output Load impedance ≥16Ω