New Product uniaxial geogrid and biaxial geogrid for increase the load-bearing capabilities

Specifications

uniaxial geogrid and biaxial geogrid for increase the load-bearing capabilities
1.Width(m):2/3.9/3.95/5/5.9/6

 New Product uniaxial geogrid and biaxial geogrid for increase the load-bearing capabilities  

 

Biaxial Geogrid Product Introduction
    Double-direction geogrid is made of high molecular polymer through extrusion, forming and punching before longitudinal and lateral stretching. This material has considerable tensile strength in longitudinal and lateral directions. This chain structure can effectively bear and diffuse forces on soil and is applicable to large area permanent load bearing foundation as a reinforce.

 

Uniaxial Geogrid Product Introduction    

    PP Uniaxial Geogrid is a high-strength geomaterial that used a high molecular polymer as the main raw, adds certain agent of anti-UV, anti-aging then stretched in one direction so as to enable the scattered catenuliform molecules re-oriented to linear conditions. It is much better than the traditional and existing reinforced materials, and it is a very good reinforced composite material for civil engineering

 

Product Features
    1. Increase the bearing capacity of the roadbed and foundation and prolong their service life. 
    2. Prevent road surface and foundation from sinking or flawing, keep clean and beautiful ground surface. 
    3. Convenient construction saves time and labor, reduce mounting time and decrease maintenance expense. 
    4. Prevent culverts from flawing. 
    5. Enhance earth slope and prevent water loss and soil erosion. 
    6. Decrease underlayer thickness and save manufacturing cost. 
    7. Enhance the stability of side slope turf net patch to improve greening. 
    8. Replace wire netting used in mine as intermediate ceiling netting.

 

Storage Methods 

 

• Uniaxial Geogrid, the length of the product roll is decided by the construction request. The rolls are to be horizontally placed and not more than 6 layers high
• Unless otherwise specified, the production should be stored in a non-corrosive gas, non-dust, well-ventilated, dry and rainproof area.
• It is recommended that the room temperature should be maintained below 35°C,and humidity should be always maintained below 65%