Produce and export wear resistant ceramic adhesives,ceramic special anti wear adhesive

5Kg/group(A component: 4Kg, B component: 1Kg),packed in a plastic drum

Packing specification of BD181 high temperature wear resistant ceramic adhesives:
Two component,5Kg/group(A component: 4Kg, B component: 1Kg),packed in a plastic drum.

performance features of BD181 high temperature resistant anti wear ceramic adhesive:
black daub shape,the temperature resistant is 200℃,with strong initial viscous force
It's consist of modified heat resistant toughening resin and special curing agent,aging resistant(can reach more than 8 years),high temperature resistant,good toughness
Can cure at room temperature,can also heat for curing
During constructing on the ceiling and facade,it doesn't flow and fall off.
When it is used as repair agent,the highest working temperature is 180℃,when it is used as structural bonding,the highest working temperature is 160℃

product usage of BD181 high temperature ceramic special abrasion resistant adhesives:
mainly used in the bonding of wear resistant ceramic chip on the ceiling and facade of the equipment. With strong initial adhesion,it won't fall off without using magnet or other support measures during construction,optimizing construction technology and reducing construction cost)

How to use of BD181 high temperature ceramic special anti abrasion adhesive:
1.  Surface treatment:Grinding or sand blasting to clean up the dust,greasy dirt and rust on the surface of adherend,finally clean it by cleaning agent.
2.  Configure adhesive: According to A:B(mass ratio)=4:1,make A and B two component mix uniformly
3.  Using adhesive:Make the configured adhesive be coating on the adherend surface uniformly.
4.  Curing:Full curing for 24 hours at room temperature,heat it up to the temperature of 80℃ and keep this temperature for 2 hours,then do the post curing,can get the higher strength(≥18MPa)
5.  The configured adhesive should be used up within the coating application time limit

Special version:
1.  This parameter is for laboratory conditions,due to the actual working condition is more complex,suggest users do pretest according to actual working condition
2.  When the environment temperature is below  15℃,the curing time will prolong,should take proper heating measure
3.  When the environment temperature is more than 25℃ or the mixing quantity is too large,the curing speed will expedite,should properly shorten the application time of coating after mixing.

Transportation storage of BD181 high temperature resistant anti abrasion ceramic adhesives:
1.Sealed storage in the cool and dry place,the warranty period is 1 year.
2.Avoid placing it upside down,knocking against and transporting it as a non-dangerous product during transportation.