Hypertherm Plasma Cutting Nozzle / Cnc Plasma Cut Parts / Hypertherm Spare Parts

Delivery Time:Prompt goods
Certification:ROHS/ SGS

Hypertherm HSD130 Nozzle 220530 For Hypertherm Plasma Cutting Machine

Shanghai ZhouBo Welding & Cutting Technology company are a professional manufacturer of plasma cutter consumables, Hypertherm plasma Cutting machine HSD130 accessories, plasma consumables. Hypertherm plasma HSD130 plasma cutting accessories, Hypertherm HSD130 plasma torch parts. Hyperherm plasma cutter nozzle 220489, plasma cutting nozzle 220492, 45A nozzle 220525, 50A nozzle 220530, hyperherm electrode 220525, plasma cutter tips 220487, hyperherm HSD130 swirl ring 220529, 130A swirl ring 220488, HSD130 Shield 220532, 220536, 220491, plasma cutter water tube 220937. plasma retaining cap 220578,

Machine	HEC NO.	Ref NO.	Description
HSD 130	H03528	220528	Electrode,(Air)45/(Oxygen)50Amp
	H02487	220487	Electrode,(Air)130/(Oxygen)130Amp
	H03415	220415	Electrode,130Amp (N2,H35)
	H73529	220529	Swirl Ring,(Air)45/(Oxygen)50Amp
	H72488	220488	Swirl Ring,(Air)130/(Oxygen)130Amp
	H13525	220525	Nozzle,45Amp (Air)
	H13530	220530	Nozzle,50Amp (Oxygen)
	H13492	220492	Nozzle,130Amp (Air)
	H13489	220489	Nozzle,130Amp (Oxygen)
	H13535	220535	Nozzle,130Amp (N2,H35)
	H33578	220578	Retaining Cap 45/50/130Amp (Air,Oxygen)
	H33534	220534	Retaining Cap 45/130Amp (N2 and F5,H35)
	H23532	220532	Shield,(Air)45/(Oxygen)50Amp
	H22536	220536	Shield,130Amp (Air)
	H22491	220491	Shield,130Amp (Oxygen)
	H03415	220415	Electrode,130Amp (N2,H35)
	H03535	220535	Nozzle,130Amp (N2,H35)
	H33534	220534	Retaining Cap 45/130Amp (N2 and F5,H35)

 

 
 
 
Technical Support:

Plasma cutting technology

Improve the cutting quality of the ten steps

7 cutting torch and workpiece perpendicular to

If the cutting torch and the material is not vertical, will cut out the angled slot. From the two aspects to check if the torch and workpiece angle of 90 degrees.

8 confirm the cutting direction

The good side is always on the cutting surface along the direction of walking on the right side of the torch (assuming the use of vortex ring is right)

9 setting the initial arcing distance

In the mechanical cutting system based on the arc starting distance guide line (see Rev. Arc adjustment range table) manually adjust the initial starting arc distance. The locking voltage regulator is highly regulated until the test cut and other parameters are determined.

4, adjust cutting speed

Select the initial cutting speed according to the cutting diagram in the operation manual. First cut and observe the angle of the plasma arc cutting workpiece. And then adjust the cutting speed to get the correct cutting arc angle.