The trend in the tube and pipe industry has been developing toward mills that can run continuously at higher speed over a greater range of thickness and width with less maintenance and greater flexibility. Horizontal spiral accumulator that SRET Equipment provides can allow for a continuous line of strip to a tube mill from a supply of non-continuous coils of strip.
Installed between shear & end welder and forming mill, SRET Equipment’s horizontal spiral accumulator will store a large amount of strip in a reasonable footprint space to give enough time for shear & end welder to cut and join the ends of two successive coils with non-stop tube mill. The principle of operation is simple. The strip is fed into the accumulator by a set of pinch rolls, before which the strip is twisted 90 degree for entering the pinch rolls. As the strip enters the accumulator, it is supported by a rotary table or a set of rollers. Therefore, the entering strip has minimum resistance, reducing the chance of strip cobbling, jam-ups, marking, tension, etc. The inside wrap of the accumulated coil is pulled thru center takeout arbor by the forming mill. The drive has three modes of stopped, line synchronized, and high-speed fill. SRET Equipment’s Strip accumulator is designed for strip to outer income and inner out feed. The number of strip wrap can be fixed or variable, depending on the thickness and width of material.
SRET Equipment is the first company in China that introduced the horizontal spiral accumulator and has been the biggest supplier of it.
Value Highlights
Grants a increased quality of end product with no mark or scratch
Scientifically designed to suit for storage of galvanized strip, bright surface strip, and automotive strip, and to ensure the welding quality of H beam steel
Prolong the service life of forming machines and rollers
Easy installation and operation
Huge storage capacity
Strip moves smoothly, no jam-ups
Wear resistant treatment applied to all rollers for longer service life
Communication with uncoiler, flattener and shear end welder, realizing one-man operation for the complete entry line section