Plc Controller Sip Equipment 8000l Cip Cleaning System

Discription:

The operating principle of the full-auto CIP cleaning system is to recycle cleaning under closed circuit, and the tank body, pipelines, pumps, all valves and the whole processing line are cleaned on line, which no need to disconnect the pipes or the equipment.

This CIP system adopt PLC program control, with colorful touch screen to operate and display the whole process flow and each control parameters. You can set the cleaning liquid temperature, the acid and alkali PH value, the cleaning time, cleaning sequence and reflux acid & alkali PH value. It contain system malfunction alarm device.

Features:

1.  Auto control cleaning liquid flow raw;

2.  Auto regulates cleaning liquid temperature;

3.  Auto control liquid level replenishment;

4.  Auto compensation acid and alkali concentration;.

5.  Auto transfer acid, alkali and hot water cleaning process;

6.  System auto alarm device

Application:

It is widely used to clean whole production line equipment or appoint equipment in the food, pharmaceutical and chemical industry.

Details:

1. Cip System:It is the tank-cleaning dvice for the rapid automation process. Pre-set system contrls the cleaning rprocess from the beginning to the end.It is simple, fast, and cleans thoroughly. The sanitary valves concerns as well as structure.

2. Equipment:Acid tank, caustia alkaine tank, and warm warer tank one for each, the recycing of detergents and adjustment of temoerarute, and liquid level  are preset.

3. CIP System Procedure:

(1) Water flow 1 second to 99 minutes 59 seconds, changed to constant temp.99°

(2) Acid clean 1 sec. to 99 min. 59sec, changed to constant temp. 99°

(3) Waterflow 1 second to 99 min. 59sec,changed to constant temp. 99°

(4) Alkaline clean 1 sec . to 99 nin. 59 sec, changed to constant temp. 99°

(5) Water flow 1 second to 99 nin. 59 sec. shanged to constant temo. 99°

(6) Sterilization 1 second to 99 nin.59sec changed to constant temp. 99°

4. CIP System Processing order:

(1) The liquid level in tank must be adjusted before operation.

(2) Cycling detergent must be released according to the switching of the flow valve. Wrong operation on LNTER LOCKin the control system stops the cycling of detergent, operation will automatically stop.

(3) Water temperature is adjusted by thermal regulator. Sst INTER LOCK operation in the control system to prevent conplete sterilization during cleaning.

(4) Air purge system starts working, most detergent can be recycled. 

(5) Buzzer sounds to indicate complerion of the operation.