Fume Extractor for Welding Soldering Smoke portable dust absorber

How to use

(1) the wind shield of the dust collector should be as close to the pollution source as possible without affecting the operation and maintenance of the mixer. In consideration of the installation and maintenance conditions, the best use of the full closed structure can be used to greatly reduce the dust removal rate. If a fully enclosed structure is not allowed, the enclosed structure with soft edge can be considered.

(2) the windshield of the dust collector of the rubber mill is not affected by the installation and maintenance. The wind shield should be used in the middle of the cover, and the air vent is left around the exit. This can greatly reduce the area of the effective section of the air cover, improve the wind speed or reduce the air volume. Under the premise that the wind speed is constant, the percentage of area reduction is equal to the percentage of air volume reduction. For example, the bag dust collector of the mixer adopts 1.5m x 0.8m square wind shield, adding windshield at the suction hood, leaving the 120mm clearance around it, reducing the ventilation volume by 80%, so that the smaller fan and dust collector can be used to achieve the basic same ventilation and dust removal effect, and a lot of cost is used for the user's day.

Design

our company can design suction hood and dust collector with different specifications according to the user's installation conditions. The wind speed of the wind cover is generally 0.5 to 1.0m/s, and the wind cover is far away from the source. If the wind shield is too far away from the source of the installation, the wind speed of the section can be increased to about 2m/s.

Structure diagram

Contact detail: 

Attn: Ada

Email: filtersales03@le-filter.com

Whatapp/mobile/wechat: 0086 18695927657

Skype: filtersales03