nitrogen gas air mass flow meter thermal mass flowmeter VA 500 /520 thermal gas mass flow sensor

VA 500 - Flow sensor for compressed air and gasesDescription VA500 Thermal mass flow sensor

Contrary to the previously used bridge circuit the newly developed evaluation electronics records all measured values digitally. 
This leads to a better accuracy also in case of large measuring 
spans of 1:1000

Specification VA500 mass flow meters

Special features of flow sensor VA 500:

• RS 485 interface, Modbus-RTU as a standard

• Option integrated display for m³/h and m³

• Usable from 1/2“ to 12“ (DN 300)

• Easy installation under pressure

• 4...20 mA analogue output for m³/h resp. m³/min

• Pulse output for m³

• Inner diameter adjustable via keypad

• Consumption counter resettable

• Adjustable values at the display of the flow sensor: Reference conditions, °C and mbar, 4...20 mA scaling, pulse weight

Detailed Images MF5000 series mass flow meters

Features Advantages of the flow measuring technology of cs instrument

1) even under pressure , the flow sensor VA 500 is mounted by means of a standard 1/2“ ball valve. During mounting and dismounting the safety ring avoids an uncontrolled ejection of the probe which may be caused by the operating pressure.
For the mounting into different pipe diameters VA 500 is available in the following  probe lengths: 120, 160, 220, 300, 400 mm.

So the flow sensor are being  mounting intoexisting pipelines with inner diameters of  1/2“ upwards.
The exact positioning of the sensor in the  middle of the pipe is granted by means of the  engraved depth scale. The maximum mounting depth corresponds with the resprective  probe length. Example: VA 500 with probe length 220 mm has a maximum mounting depth of 220 mm.

2) If there is no suitable measuring site with a 1/2“ ball valve present there are two simple possibilities to set up a measuring point:
A Weld on a 1/2“ screw neck and screw on a 1/2“ ball valve
B Mount spot drilling collar incl.
ball valve (see accessories)

By means of the drilling jig it is possible to  drill under pressure through the 1/2“ ball  valve into the existing pipeline. The drilling 
chips are collected in a filter. the the probe can be mounted as described under point A

3) Due to the large measuring range of the probe even extreme requirements to the consumption measurement (high volume flow in small pipe diameter) can be met.
The measuring range is depending on the pipe diameter - see table on the right hand side.

Company Information

Contact us

Company Information

Contact us: 

Emma Zhao

Mobile: +86 18629367136

What'sapp: +86 18629367136

Skype: emma02281 

WeChat:  18629367136

Email: sales.c@7deadweighttester.com   zjmm0228@163.com