Anti-Splash Tape Coated With High Temperature Silicone Adhesive

ANTI-SPLASH TAPE USED IN MARINE & OFFSHORE

Anti-Splash tape is constructed of an aluminum or glass cloth laminate coated with a high temperature silicone adhesive.

Anti-Splash tape is enhanced with a fire retardant (self-extinguishing) adhesive layer. At the same time, it is also water resistant. In addition, the maximum working temperature of tape is up to 150 °C.

It is designed to prevent hazardous liquids (oil/fuel) spraying outs or leaking from tubing systems. These liquids can cause extremely dangerous situations like fires, explosions or other dangerous situations.

Anti-Splash tape is widely used to wrap around tubing, hoses, fittings, flanges, and valves in the marine and offshore industry.

COMMON SPECIFICATIONS

IMPA Code Width (mm) Width (inch) Length (m) Roll/Box

871801 35 1.38 10 28

871802 50 1.97 10 20

871808 75 2.95 10 12

871804 100 3.94 10 12

871803 140 5.51 10 7

871804 250 9.84 10 4

871805 500 19.68 10 2

871806 1000 39.37 10 1

PHYSICAL PROPERTIES AND PERFORMED TESTS

Total thickness 9.5 mils

Colour Silver

Max. temperature Up to 150 °C (300 °F)

Pressure 300 psi

Tensile strength 93.2 lbs. per inch (ASTM-882)

Adhesion Above 1000 grams, 25 mm g/f

Adhesion to steel 5.8 lbs. per inch (ASTM-33330)

Aging properties Indefinite shelf life when properly stored

INSTALLATION STEPS

Three steps to install anti-splash tape on the flange.

Steps for installing anti-splash tape on the flange

  Three steps to install anti-splash tape at the junction of the two pipes.

Steps for installing anti-splash tape on pipes

 This picture shows the different conditions before and after using anti-splash tapes.

Different conditions before and after using anti-splash tapes

APPLICATIONS

Fuel oil injection pipes, fuel oil service pipes, fuel oil valve cooling oil pipes attached to diesel engines.

Flammable oil pipes, pump and strainer.

Lube oil service pipes and hydraulic oil pipes attached to diesel engines.

Fuel oil heater.

The preceding areas of fire risk should be protected from the following sources of ignition:

Exhaust gas pipe.

Steam pipe.

Turbo charger.

Electrical equipment.

Boiler, thermal oil heater and incinerator.

Anti-splash tapes are attached on the fuel pipes.

Anti-splash tapes for fuel pipes

  Anti-splash tapes wrap the connection of the tubes on the motor.