Home > Products > 18650 cylindrical power lithium-ion batteries > power tool lithium ion battery supplier
power tool lithium ion battery supplier
- 12 Piece / Pieces per Month
- SHANGHAI
- T/T L/C
- 30 days
Product Details
Brand Name: | Sunpower | Place of Origin: | China |
Product Description
INR18650-3000mAh Li-ion Rechargeable cylindrical battery,18650 battery,High security lithium ion battery,power tool lithium ion battery supplier
Safety Characteristic of car 18650 battery
NO. | Item | Standard | Test Method |
1 | Overcharge | No fire、No explosion | After standard charge, rest for 10mins; then charge at constant current of 3C to 10V.(or charge at 3C for90mins). |
2 | Forced discharge | No fire、No explosion | The battery to be discharged with standard discharging condition, Inverse charge current =1C;time: ≥90mins |
| Short Circuit test | No fireNo explosion | The battery to be fully charged with standard charging condition, and short the positive and negative terminals with wire resistance ≤50mΩ.Tests are to be conducted at 23℃±3℃ and at 55℃ ±5℃, keep 24h or casetemperature decline to 20% of the max temperature ,test is over. |
4 | Crush test | No fire/No explosion | A battery is crushed between two flat surfaces. The applied force is 13 kN±1kN by hydrocylinder, Once the maximum pressure has been obtained or voltage decrease to 1/3 of nominal voltage sharply, then release pressure. |
5 | Shock test | No fire/No explosion | The full charged battery is fixed on shock table, to force a certain shock to three mutual vertical direction, in initial3ms, the min. average acceleration is 75gn,the peak acceleration is between 125gn and 175gn. |
6 | Heating test(130°C) | No fire/No explosion | The cells are fully charged with standard charging condition, and put into incubator with nature air or cycled air convected, heat battery by velocity of 5°C ±2°C/min to130°C±2°C,and maintain for 10mins. |
7 | TemperatureCycling Test | no leakage, no fire, no explosion | The fully charged batteries are placed in a test chamber and subjected to the following cycles: a) Raising the temperature to 75°C ±2°C within 30 minutes and maintaining this temperature for 6 hours. b) Reducing the temperature to minus 40°C ±2°C within30 minutes and maintaining this temperature for 6 hours. c) Repeating the sequence for a further 9 cycles. d) Afterthe 10th cycle, storing the batteries for 24 hours prior to examination. |
Environment Adaptation Performance for 18650 lithium ion battery supplier
NO | Item | Standard | Test Method |
1 | Altitude/Low pressure simulation test | no leakage, no fire, no explosion | The full charged cells are to be stored for 6h at an vaccum environment with pressure of less than 11.6kPa and atemperature of 23℃±3℃. |
2 | Free drop test | no fire, no explosion | The fully charged battery drops on the concrete ground from height(1m),total 3 times,to obtain the shock of random directions. |
3 | Vibration test | No remarkable damage、No smoking 、No explosion | After standard charging, fixed the cell to vibration table and subjected to vibration cycling that the frequency is to be varied at the rate of 1Hz per minute between 10Hz and 55Hz,the excursion of the vibration is 1.52mm. The cell shall be vibrated for 90 minutes per axis of x, y axes |
Storage Temperature for Shipping
If the cell is kept as ex-factory status (50% of charge), the 0.2C recoverable capacity rate is more than 90%.
1 month -20°C ~ 60 °C
2 months-20°C ~ 40 °C
3 months-20℃~ 25 °C
Appearance
There shall be no such defect as deep scratch, flaw, crack, rust, leakage, which may adversely affect commercial value of the cell.
Package
The cells are packed with JIANGSU SUNPOWER CO.,LTD. standard carton box, which hold four inner boxes. There are 100pcs 18650 cells per inner box. And the inner box and outer box identifies battery capacity, voltage and impedance information.
Warranty Period & Product Liability for High security lithium ion battery
Warranty period of this product is 12 months from manufacturing code. JIANGSU SUNPOWER CO., LTD. is not responsible for the troubles caused by mishandling of the battery which is against the instructions in this specification.
Warnings and Cautions in Using the Battery
To prevent a possibility of the battery from leaking, heating or explosion please observe the following precautions:
● When using a new battery for the first time or after long term storage, please use the battery charger specifically for that purpose fully charge the battery before use.
● Do not disassemble or open, crush, bend or deform, puncture, or shred;
● Do not modify or remanufacture, attempt to insert foreign objects into the battery, immerse or expose to water or other liquids such as water, seawater, drinks such as soft drinks, juices, coffee or others, or expose to fire, explosion, or other hazard.
● Do not short circuit a battery or allow metallic or conductive objects to contact the battery terminals.
● Avoid dropping the phone or battery. If the phone or battery is dropped, especially on a hard surface, and the user suspects damage, take it to a service center for inspection.
● The battery replacement shall be done only by either cells supplier or device supplier and never be done by the user.
● Replace the battery only with another battery that has been qualified with the system per standard. Use of an unqualified battery may present a risk of fire, explosion, leakage, or other hazard.
● Don’t keep a battery at rest for a long time (over 6 months). Safety accident may happen when recharging battery which has a rest for a long time.
● In the event of a battery leak, do not allow the liquid to come in contact with the skin or eyes. If contact has been made, wash the affected area with large amounts of water and seek medical advice.
● Battery usage by children should be supervised. Seek medical advice immediately if a battery has been swallowed
● Never disassemble cells. The disassembling may generate internal short circuit in the cell, which may cause firing or other problems.
● Never incinerate nor dispose the cells in fire. These may cause firing of the cells, which is very dangerous and is prohibited.
● When use the battery , must to ensure the charge and discharge voltage of the battery is between 2.75V to 4.2V.
● Do not remove the outer sleeve from a battery pack nor cut into its housing.
● Do not mix our batteries with other battery brands or batteries of a different chemistry such as alkaline and zinc carbon.
● Do not mix new batteries in use with semi-used batteries, over-discharge may occur.
● Promptly dispose of used batteries in accordance with local regulations.
The company founded in 2014, focus on producing cylindrical power lithium-ion batteries. The company supply Electric vehicle cylindrical lithium battery, which include 1500mAh, 1300mAh, 2000mAh, 2200mAh, 2500mAh, 2600mAh Li-ion battery and 3000mAh Li-ion battery. All adopt the most advanced extrusion coating production technology and yearly production reaches to 250 million Ah power type 18650 High security lithium ion battery. Our products have high quality and competitive prices.
If you want to learn more about the High security lithium ion battery, please visit here.
/
More information:
http://www.rubberotik.de
http://www.ralfelectrician.uk
http://
http://
Contact Us
- Jiangsu Sunpower Co., Ltd.
- Contact nameYuanyuan Zhang
- Phone86-0512-58566663
- AddressNo. 8, Xingyuan Road, Huangqiao Industrial Park, Taixing Taizhou,Jiangsu
18650 cylindrical power lithium-ion batteries | News |
- [Lithium ion battery for sale]Lithium ion battery is discussed
- The development of lithium ion batteries
- Warranty Period & Product Liability Of INR18650-1300mAh Li-ion Rechargeable cylindrical battery
- The main battery electrode material
- What is the reason of lithium battery battery drum shell?
- Why can't lithium batteries be charged at low temperature?
- What to pay attention to when charging a lithium battery?
- How long does it take to charge the 18650 rechargeable lithium battery?
- Lithium battery charging time and discharge time calculation
- The composition and main role of lithium battery protection board
- What Is The Charging Process For Lithium-ion Batteries?
- The working principle of lithium battery protection plate
- Function introduction of main parts of lithium battery protection board
- Does lithium battery protection plate have balance function?
- What are the precautions when using lithium batteries?
- Background of high voltage technology development for lithium ion batteries
- Li-ion Rechargeable cylindrical battery
- [Science] Battery fast charging technology
Popular Searches
- home storage
- rechargeable battery
- external battery
- lithium battery
- lithium ion battery
- lifepo4 battery
- Lifepo4 Battery Pack
- Storage Battery Pack
- Liion Battery
- Rechargeable Lithium Battery
- Cell Lithium Battery
- Lipo Battery
- Lithium Polymer Battery
- Home Appliance Battery
- Emergency Power Supply
- portable storage
Find Similar Products By Category
- Electrical Equipment & Supplies > Batteries > Rechargeable Batteries
- Buy on GoldSupplier.com
- How to Buy
- Browse by Catagories
- Browse by Hot Regoins
- Private Sourcing Events
- Sell on GoldSupplier.com
- How to Sell
- Post Products
- Manage Products
- Manage Groups
- About
- About Us
- Link to Us
- Contact Us
- Sitemap
- Please Enter your Email Address
- Please enter the content for your inquiry.
We will find the most reliable suppliers for you according to your description.
Send Now-
Yuanyuan Zhang
Welcome to my shop! Glad to serve you!Please send your question!
Your message has exceeded the limit.
Your message has exceeded the limit.
-
-
Your inquiry content must be between 20 to 5000 characters.Send Now.
-
Please input the mailbox.
-