XCore407I, STM32F4 Core Board

XCore407I is an STM32 MCU core board that features the STM32F407IGT6 on board.

• Clock circuit, USB power management

• Onboard devices: USB HS PHY,Ethernet PHY,1G Bit NandFlash

• Connectors:USB HS (mini / type A), USB FS (mini), Ethernet (RJ45)

• All the idle I/O ports are accessible on the pin headers

• 2.0mm pin header pitch, smaller size, easier to integrate into user system

Note : please consider the EVK407I, which supports easily programing/debugging.

1. STM32F407IGT6:the high performance STM32 MCU which features:

• 3 x SPI, 4 x USART, 2 x UART, 2 x I2S, 3 x I2C

• 1 x FSMC, 1 x SDIO, 2 x CAN

• 1 x USB 2.0 high-speed/full-speed device/host/OTG controller with dedicated DMA, ULPI and on-chip full-speed PHY

• 1 x 10/100 Ethernet MAC

• 1 x 8 to 14-bit parallel camera interface

• Core: Cortex-M4 32-bit RISC

• Feature: a full set of single-cycle DSP instructions

• Operating Frequency: 168MHz, 210 DMIPS/1.25 DMIPS/MHz

• Operating Voltage: 1.8V-3.6V

• Package: LQFP176

• Memories: 1024kB Flash, 192+4kB SRAM

• MCU communication Interfaces:

• AD & DA converters: 3 x AD (12-bit, 1μs, shares 24 channels); 2 x DA (12-bit)

• Debugging/Programming: supports JTAG/SWD (serial wire debug) interfaces, supports IAP

2. MIC2075-2, onboard USB FS power management device

3. AMS1117-3.3, 3.3V voltage regulator

4. K9F1G08U0E, 1G Bit NandFlash

5. DP83848, Ethernet PHY

6. MIC2075-1, onboard USB HS power management device

7. USB3300, USB HS PHY

8. Power supply switch, powered from 5Vin or USB connection

9. Boot mode switch, for configuring BOOT0 pin

10. Power indicator

11. USB FS LED

12. USB HS LED

13. Reset button

14. 8M crystal, MCU clock, enables the MCU run at higher speed by frequency multiplication

15. 24M crystal, USB3300 clock

16. 50M crystal, DP83848 clock

17. 32.768K crystal, for internal RTC with calibration

18. Ethernet connector

19. USB FS mini connector

20. USB HS mini connector

21. USB HS type A connector

22. MCU pins expander, VCC, GND and all the idle I/O ports are accessible on expansion connectors for further expansion

23. USB OTG/HOST jumper

24. VREF/VBAT jumper

25. Ethernet I/O selection solder joint

26. USB HS I/O selection solder joint

27. PDR selection solder joint: 1.8-3.6V, -40~105℃ OR 1.7-3.6V, 0~70℃

Contact Us

Yiwu Kunchang E-commerce Firm

Contact namelinda Chat Now

• *Email
  Please enter Your valid email address.
• *To

  

  linda
• *Message
  Your inquiry content must be between 20 to 5000 characters.
•  

  Please enter a correct verification code.

Send Now