Stm32f107vct6 ARM microcontroller - MCU st original stock

equipment.

Features
• Core: ARM® 32-bit Cortex®-M3 CPU
– 72 MHz maximum frequency, 1.25 
DMIPS/MHz (Dhrystone 2.1) performance 
at 0 wait state memory access
– Single-cycle multiplication and hardware division
• Memories
– 64 to 256 Kbytes of Flash memory
– 64 Kbytes of general-purpose SRAM
• Clock, reset and supply management
– 2.0 to 3.6 V application supply and I/Os 
– POR, PDR, and programmable voltage 
detector (PVD)
– 3-to-25 MHz crystal oscillator
– Internal 8 MHz factory-trimmed RC
– Internal 40 kHz RC with calibration
– 32 kHz oscillator for RTC with calibration
• Low power
– Sleep, Stop and Standby modes
– VBAT supply for RTC and backup registers
• 2 × 12-bit, 1 µs A/D converters (16 channels)
– Conversion range: 0 to 3.6 V
– Sample and hold capability
– Temperature sensor
– up to 2 MSPS in interleaved mode
• 2 × 12-bit D/A converters
• DMA: 12-channel DMA controller
– Supported peripherals: timers, ADCs, DAC, 
I2Ss, SPIs, I2Cs and USARTs
• Debug mode
– Serial wire debug (SWD) & JTAG interfaces
– Cortex®-M3 Embedded Trace Macrocell™
• Up to 80 fast I/O ports
– 51/80 I/Os, all mappable on 16 external 
interrupt vectors and almost all 5 V-tolerant
• CRC calculation unit, 96-bit unique ID
• Up to 10 timers with pinout remap capability
– Up to four 16-bit timers, each with up to 4 
IC/OC/PWM or pulse counter and 
quadrature (incremental) encoder input
– 1 × 16-bit motor control PWM timer with 
dead-time generation and emergency stop
– 2 × watchdog timers (Independent and 
Window)
– SysTick timer: a 24-bit downcounter
– 2 × 16-bit basic timers to drive the DAC
• Up to 14 communication interfaces with pinout 
remap capability
– Up to 2 × I2C interfaces (SMBus/PMBus)
– Up to 5 USARTs (ISO 7816 interface, LIN, 
IrDA capability, modem control)
– Up to 3 SPIs (18 Mbit/s), 2 with a 
multiplexed I2S interface that offers audio 
class accuracy via advanced PLL schemes
– 2 × CAN interfaces (2.0B Active) with 512 
bytes of dedicated SRAM
– USB 2.0 full-speed device/host/OTG controller 
with on-chip PHY that supports HNP/SRP/ID 
with 1.25 Kbytes of dedicated SRAM
– 10/100 Ethernet MAC with dedicated DMA 
and SRAM (4 Kbytes): IEEE1588 hardware 
support, MII/RMII available on all packages