Mitsubishi touch screen GS2107-WTBD7-inch economy

Mitsubishi touch screen GS2107-WTBD7-inch economy

Mitsubishi touch screen GS2107-WTBD 7-inch economy

1. Resolution: WVGA 800 * 480

2. Program capacity: 9MB

3. Display: TFT color LCD 65536 color

4. Corresponding to RS-422 and RS-232

5. Built-in Ethernet

6. Built-in USB

7. Equipped with SD card slot

8. IP65F environment-proof construction

9. Vertical display

GS2107-WTBD power supply specification:

Input power supply voltage: DC24V (+10%, - 15%) ripple voltage below 200mA

Consumer power: less than 6.5W 271mA/24V backlight, less than 3.8W (158mA/24V)

Impulse current: below 17A (6ms, 25 ℃, load)

Allowable instantaneous stop time: within 5ms

Anti-noise performance: comply with IEC61000-4-4 2kV (power line)

Withstand voltage: AC350V for 1 minute (between all power terminals of GOT<=>ground terminals of GOT)

Insulation resistance: more than 10M Ω measured by DC500V megger (between all power terminals of GOT<=>ground terminals of GOT)

GS2107-WTBD performance specification:

1. Display part:

Type: TFT color LCD

Picture size: 7 inches 7 inches 7“

Resolution: 800 * 480

Display size: W155 * H86.5 [mm] (horizontal display)

Number of characters displayed: in 16-point font: 50 characters * 30 lines (full width) (in horizontal display)

Display color: 65536 colors

2. Backlight

LED mode (not replaceable)

Backlight OFF/screen protection time can be set

3. Touch panel

Mode: analog resistance film mode

Touch key size: * * 2 * 2 [points] (each touch key)

Press at the same time: Do not press at the same time (only touch 1 point)

Service life: 1 million times (operating force below 0.98N)

4. Memory

C drive: built-in flash card 9M bytes

Service life: 100000 times

5 Built-in interface

RS-422：RS-422, lch

Transmission speed: 115200/57600/38400/19200/9600/4800bps

Connector shape: D-Sub 9-pin (female)

Purpose: for connecting equipment communication

Terminal resistance: 330 Ω fixed

RS-232：RS-232, lch

Transmission speed: 115200/57600/38400/19200/9600/4800bps

Connector shape: D-Sub 9-pin (female)

Purpose: for connecting equipment communication and barcode reader

For connecting computers (software package data upload/download, FA transparent function)

Ethernet: data transmission mode: 100BASE-TX, 10BASE-T, 1ch

Connector shape: RJ-45 (module jack)

Purpose: for connecting equipment communication and gateway function

For connecting computers (software package data upload/download, FA transparent function)

USB: according to serial USB (full speed 12Mbps) standard, lch

Connecting base voltage: Mini-B

For connecting computers (software package data upload/download, FA transparent function)

SD card: according to SD specification 1ch

Support memory card: SDHC memory card, SD memory card

Purpose 2 Software package data upload/download, log data storage

6. Beeper output: single voice (long/short/no adjustable)

7. Protection structure: IP65F (only the front part of the panel)

8. Mass: about 0.9kg (excluding metal fittings for installation)

9. Corresponding software package (version of GT Designer3): Version 1.105K later

1. Mitsubishi full series PLC, frequency converter, human-machine interface, servo system.

2. Xinjie PLC, frequency converter, human-machine interface and servo system.

3. Delta PLC, frequency converter, human-machine interface and servo system.

4. Wellington human-machine interface and Hytec human-machine interface.

Mitsubishi servo motor HG-JR15K1MB;

Mitsubishi servo motor HG-JR11K1MB;

Mitsubishi servo drive MR-J4-11KA

Mitsubishi servo drive MR-J4-11KB

Mitsubishi servo drive HG-KR-23J with oil seal

Mitsubishi servo store HG-KR053

Mitsubishi servo motor HG-KR73BJ with oil seal

Mitsubishi servo motor HG-SR102BJ with oil seal

Mitsubishi MR-J4-15KB servo driver

Mitsubishi PLC (programmable controller) A, R, Q, L, CC-LNK, FX3SA, FX3G, FX3G, FX3U, FX5U and other series;

Mitsubishi frequency converter A840, E840, F840, E740, D740, D720 series; Mitsubishi touch screen GT2000 series; Mitsubishi servo motor JE, J4 series.

Mitsubishi programmable controller: FX3GA, FX3GE, FX3G, FX3U, FX3UC, FX2NC, A, Q, CC-LINK remote module and other series

Mitsubishi variable frequency governor: FR-L700, FR-A700/500, F700/500, E700/500, D700/500, S500 and other series;

Man-machine interface: GOT2000, GOT16, GOT15, GOT12, GOT11, GOT10, A900GOT, F900GOT and other series;

AC servo system: MR-J4, MR-JE, MR-J3, MR-J2S, MR-E, MR-ES and other series;

Tension control system: LE-40MTA (B), LD-FX, LD-50PAU and other series:

Low-voltage electrical appliances: S-N, TH-N, etc.