A multi-purpose fully synthetic copper wire drawing lubricant

DRR  LS11 A multi-purpose fully synthetic copper wire drawing lubricant

DESCRIPTION

A Combination of specially designed additives have been used to produce a synthetic lubricant with

exceptionally high lubricity and anti-wear properties. The product was also designed to overcome

some of the historic issues associated when using synthetics, especially corrosion of machine parts.

APPLICATIONS 

The properties built into DRR  LS11 allow for a wide range of uses.

- Superfine copper wire 

- Fine copper wire 

- Suitable for both single and multi-wire drawing machines

- Eminently suitable for enameled wire manufacture

- Plated wires and alloy wires 

- Precious metal wires

PRODUCT HIGHTLIGHTS 

- Excellent lubrication and corrosion inhibition performance  

- Overcome issues with wire sticky dies and cones   

- Excellent detergency helps wash copper particles back to the filter /lubricant holding tank

- Wire produced is smooth, clean and bright  

- Production boosted due to reduction in wire breaks and downtime

RECOMMENDED INSTRUCTIONS FOR USE 

- Before preparing a solution of DRR  LS11 for use ensure the complete lubricating system is

- Where wire surface cleanliness and brightness is a key factor it is recommended to use deionized

water for preparing the solution and subsequent top up. Maximum recommended hardness of

water is 150ppm CaCO₃.

- Operating temperature should be in the range of 30 – 40 °C for best results. 

- DRR  LS11 mixes with water to form a solution not an emulsion like typical semi-synthetics. Mixing is much easier or reduce the chance of mixing problems during makeup .

RECOMMENDED SOLUTION CONCENTIONS

Finishing           0.03 - 0.08mm         10 - 15%

Finishing          0.08 - 0.15mm         15 - 20%

Finishing           0.15 - 0.30mm         20 - 35%

PACK SIZES 

DRR  LS11 is filled in 200kg steel drums.

TECHNICAL DATA 

CONCENTRATION MONITORING

Emulsion concentration is generally measured using a refractometer measuring on the Brix scale.

To obtain the actual concentration multiply the refractometer reading by the correction factor 1.83

e.g., Refractometer reading            = 1.5

Correction factor                        1.83

Read actual concentration               = 2.75%

STORAGE

Keep drums protected from direct sunlight and frost. Storage temperature should be controlled to

between 5°C and 35°C.

Nantong Inswell Lube Tech Co., Ltd

Factory address:  19-D, Zhennan Road, Jiang’an Town, Rugao, Jiangsu, China

Pre/Post-Sales Add: 21-601, Henghua Park, Wuxi ，Jiangsu, China

Email:  amy@czanthem.com

web: htttp://