Damival® 13650 0000 / 13500 0000 Two parts polyurethane casting resin

Damival® 13650 0000 / 13500 0000

► Flexible elastomeric compound

► Very hydrophobic grade

► Good adhesion

► Suitable for very low temperature

► Low dielectric constant

General description

Two parts polyurethane casting resin.

Application

Casting resin for encapsulation of Printed Circuit Boards Assemblies, transformers, ...

Processing

The resin must be stirred before use, as it contains fillers which can settle during storage. Avoid air introduction during stirring.

Polyurethane resin and hardener are sensitive to moisture during the processing steps (storage, mixing, casting). The parts to be

casted shoud be dry and clean.

A preheating of the parts and/or of the resin and hardener can improve the encapsulation. A vacuum processing enhance the

dielectrical and mechanical properties.

Mixing can be done by machine or manually.

The gel time and the curing time depend on the mixed volume, the temperature and the thickness of the layer.

Final properties are depending on the curing level.

Mixing ratio (resin/hardener):

Weight: 100 / 33

Volume: 100 / 26

Storage Conditions

Resin : 12 months in original packaging, at maximum 25°C, protected from moisture. Possible storage at higher temperature for

short period of time. A storage above 25°C will increase the settling.

Hardener: 12 months in original packaging, at maximum 25°C, protected from moisture. Possible storage at higher temperature for

short period of time. May crystallise below 5°C. In such case, warm up to 60°C until crystals disappear, and stir before use.

Packaging

Resin : 18kg, 180 kg metallic drums,

Hardener : 5 kg, 25 kg, 250 kg metallic drums,

Other packaging upon request

Health and safety

- Avoid any contact with skin and eyes

- Work in a well ventilated area,

- Wear safety gloves, goggles and work clothes.

Read the Material Safety Data Sheet for complete information.