The PFXA401SF Millmate controller 400 is designed to provide a large number of functions.

The PFXA401 Millmate controller 400 is designed to provide a large number of functions and is highly user-friendly. The control unit covers the installation possibilities of all edge sensors. This means that the user only needs to set up the control unit according to the step-by-step instructions and calculate the correct position and width of the edge and center of the material belt. Calculate the digital minimum value of the analog/digital input/output digital edge position level detector, which is easy to configure from 10ms to the real strip position and width filtering time of the rolling mill. And max. Width horizontal detector unit selection (mm, inch) The self-diagnosis test system including continuous edge sensor test is easy to check the simulation mode of system integration.External connection: 2 analog inputs and 4 analog outputs with nominal thickness and nominal width, 8 digital inputs and 8 digital outputs of voltage or current, external equipment +24 V power supply. 0.5 Amp Ethernet connected to:Other mill control and operation devicesOther control systems using VIP protocol have two RS-232 serial interfaces for external display and control. High Speed Fieldbus (Optional) PerformanceDimensions (height x width x depth) 380 x 235 x 90 mmWeighing 5 kgProtection level IP 20Power supply voltage 85-264V, power consumption 140VAThe working temperature is 0 to +70 degrees Celsius.Storage temperature -40 to +70 degrees Celsius analog input 0-10 V, 10 V differential input analog output voltage 0-10 V current 0-20 mA 4-20 mA step response 20 ms (0-90%) digital input 0/+24 V, insulation 4+4 digital output 0/+24 V, insulation 4+4 V.